• Tungsten Carbide Drills For drilling PCBs. 
  Two flutes, righthand turn. Diameter: 0.3 ... 3.0 mm in 0.1 mm increments

• Contour Routers - RPU Type 
  For Aluminium routing/milling. Two flutes, upward swarf ejection, fish tail tipped. On-stock diameters: 0.8, 1.0, 1.2, 1.5, 2.0, 2.5, 3.0 mm

• Contour Routers - SC/FT Type 
  For PCB routing, spiral shaped teeth, upward swarf ejection, fish tail tipped. On-stock diameters: 0.8, 1.0, 1.3, 1.5, 2.0, 2.5, 3.0 mm

For isolation milling under 0.6 mm we offer:

• SC FT Router cylindrical:
  0.5, 0.4 und 0.3 mm

• Bungard Special isolation milling routers 0.1 and 0.2 mm:
  These routers are cylindrical only in the last Millimetre. This way there is less risk of breaking the router. For experienced operators

or:

• V-Cut Routers G30°N Type
  For Isolation routing and fine engraving, two flutes, 30° tip angle. For Channels of 0.1 – 0.3 mm width (depending on cutting depths).
• Contour Routers G60°N Type
  For Isolation routing with or for engraving. Two flutes, 60° tip angle. For Channels of 0.2 – 0.5 mm width (depending on cutting depths).